Network Video Recorder User Manual
49
4. Drag the mouse on the time bar to set the continuous recording schedule. Refer to Configure
Recording Schedule for details.
4.1.7 Configure Motion Detection Triggered Recording
You can configure the recording triggered by the motion detection event.
Steps
1. Go to System → Event → Normal Event → Motion Detection.
2. Configure the motion detection and select the channel (s) to trigger the recording when motion
event occurs. Refer to Configure Linkage Actions for details.
3. Go to Camera → Encoding Parameters → Recording Parameters.
4. Set the event main stream/sub-stream recording parameters for the camera.
5. Go to Storage → Recording Schedule.
6. Select the recording type to Motion.
7. Drag the mouse on the time bar to set motion detection recording schedule. Refer to Configure
Recording Schedule for details.
4.1.8 Configure Event Triggered Recording
You can configure the recording triggered by the motion detection, motion detection and alarm,
face detection, vehicle detection, line crossing detection, etc.
Steps
1. Go to System → Event.
2. Configure the event detection and select the channel(s) to trigger the recording when event
occurs. Refer to Event for details.
3. Go to Camera → Encoding Parameters → Recording Parameters.
4. Set the event main stream/sub-stream recording parameters for the camera.
5. Go to Storage → Recording Schedule.
6. Select the recording type to Event.
7. Drag the mouse on the time bar to set the event detection recording schedule. Refer to
Configure Recording Schedule for details.
4.1.9 Configure Alarm Triggered Recording
You can configure the recording triggered by the motion detection, face detection, vehicle
detection, line crossing detection, etc.
Steps
1. Go to System → Event → Normal Event → Alarm Input.
2. Configure the alarm input and select the channel(s) to trigger the recording when alarm occurs.
Refer to Event for details.
3. Go to Camera → Encoding Parameters → Recording Parameters.
To Next Page
Loading...
Need help?
General
