Network Video Recorder User Manual
114
usage as Video Structuralization-Real-Time. Refer to Engine Configuration for details.
Steps
1. Go to Smart Analysis → Smart Event Settings → Video Structuralization.
2. Select a camera.
3. Check Enable Multi-Target-Type Detection.
4. Optional: Check Save VCA Picture to save the captured intrusion detection pictures.
5. Optional: Check Enable NVR Smart Analysis. The device will analyze the video, cameras only
transmit video stream.
6. Set detection area.
1) Click Draw Area.
2) Adjust the red frame on the image to draw the detection area. It is full screen by default.
3) Click Stop Drawing.
7. Optional: Set Capture Quality. The captured picture will be stored to the device, high quality
brings higher resolution, but it takes larger storage space. Picture quality will not affect
detection accuracy.
8. Set the arming schedule. Refer to Configure Arming Schedule.
9. Set the linkage method. Refer to Configure Linkage Actions.
10. Click Apply.
7.8 Vehicle Detection
Vehicle detection is available for the road traffic monitoring. In vehicle detection, the passed
vehicle can be detected and the picture of its license plate can be captured. You can send alarm
signal to notify the surveillance center.
7.8.1 Configure Vehicle Detection
Vehicle detection, available in the road traffic monitoring, is tend to detect the passed vehicle on
the road, and capture its license plate at the same time.
Steps
1. Go to Smart Analysis → Smart Event Settings → Vehicle Detection.
2. Select a camera.
3. Click Vehicle.
4. Check Enable Vehicle Detection.
5. Optional: Check Save VCA Picture to save the captured vehicle detection pictures.
6. Configure rules, including Area Settings, Picture, Overlay Content, and Blocklist and Allowlist.
Area Settings
Up to 4 lanes are selectable.
Blocklist and Allowlist
You can export the file first to see its format, and edit it and import it to the device.
To Next Page
Loading...
Need help?
General
