CYLINDER HEAD/VALVES
9-21
CAMSHAFT/ROCKER ARM
INSTALLATION
CAMSHAFT/ROCKER ARM INSTALLA-
TION
Do not exchange
the intake and
exhaust rocker arm
shafts.
Apply molybdenum oil solution to the sliding sur-
face of the rocker arms and shafts.
Clean the rocker arm shaft holes and camshaft bear-
ing mating area.
Install the rocker arms and side springs as shown.
Install the rocker arm shafts to the cylinder head.
Apply molybdenum oil solution to the camshaft
bearing and cam lobes.
Install the camshaft with the cam lobe facing the
cylinder side while pressing down on the valve side
of the rocker arm.
Apply locking agent to the stopper plate bolt
threads (page 1-16).
Install the stopper plate, stopper bolt to the cylinder
head as shown and tighten the bolt to the specified
torque.
Install the rocker
arm shafts with the
cut-out facing rear
side.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
To Next Page
Loading...
Need help?
General
