FRAME/BODY PANELS/EXHAUST SYSTEM
3-16
SIDESTAND
Remove the following:
– left floor side cover (page 3-8)
– sidestand switch (page 22-21)
Support the scooter securely using the centerstand.
Unhook the return springs.
Remove the pivot nut, bolt and sidestand.
Installation is in the reverse order of removal.
At installation, apply grease to the pivot bolt sliding
surfaces.
CENTERSTAND
Retract the centerstand and support the scooter
securely.
Remove the following from the right side:
– spring
– cotter pin
Remove the following from the left side:
– spring
– mounting bolt
– mounting collar
– pivot shaft
– centerstand
Installation is in the reverse order of removal.
• Apply grease to the pivot areas.
• Always replace the cotter pin with new one.
TORQUE:
Sidestand pivot bolt 10 N·m (1.0 kgf·m, 7 lbf·ft)
Sidestand pivot nut 30 N·m (3.1 kgf·m, 22 lbf·ft)
COTTER PIN
SPRING
CENTERSTAND
CENTERSTAND
SPRING
BOLT
PIVOT SHAFT
COLLAR
To Next Page
Loading...
Need help?
General
