HYDRAULIC BRAKE
17-32
ABS type only. Support the scooter securely using a hoist or equiv-
alent and raise the wheel off the ground.
Measure the clearance (air gap) between the sensor
and pulser ring at several points by turning the
wheel slowly.
It must be within specification.
The sensor air gap cannot be adjusted.
If it is not within specification, check each installa-
tion part for deformation, looseness and damage.
REAR BRAKE CALIPER
REMOVAL
Remove the following:
– exhaust pipe/muffler (page 3-15)
– brake hose protector (page 16-5)
Drain the brake fluid from the rear (combined) brake
line hydraulic system (page 17-7).
Disconnect the brake hose from the rear brake cali-
per by removing the oil bolt and sealing washers.
Remove the following:
– two mounting bolts
– brake caliper
– rear brake pads (page 17-14)
DISASSEMBLY
Remove the following:
– Caliper bracket
– Retainers
– Pin boots
– Caliper pin
STANDARD: 0.2 – 1.2 mm (0.01 – 0.05 in)
When removing the
brake hose oil bolt,
cover the end of the
hose to prevent
contamination.
OIL BOLT
BRAKE HOSE
SEALING WASHERS
MOUNTING BOLTS
REAR BRAKE CALIPER
CALIPER BRACKET
CALIPER BODY
PIN BOOTS
CALIPER PIN
RETAINERS
To Next Page
Loading...
Need help?
General
