FRAME/BODY PANELS/EXHAUST SYSTEM
3-8
FRONT FENDER
Remove the following:
– three special bolts
– front fender
Installation is in the reverse order of removal.
FLOOR SIDE COVER
Remove the bolt and special bolt.
Release the rear end slot of the floor side cover from
the tab on the floor panel.
Release the three hooks and three tabs on the floor
side cover from the grooves on the floor panel.
Remove the floor side cover by releasing the two
tabs on the floor side cover from the grooves on the
front lower cover.
Installation is in the reverse order of removal.
TORQUE: Front fender mounting bolt
12 N·m (1.2 kgf·m, 9 lbf·ft)
FLOOR SIDE
COVER
BOLT
left side shown:
SPECIAL BOLT
SLOT
HOOKS
To Next Page
Loading...
Need help?
General
