GENERAL INFORMATION
1-7
LUBRICATION SYSTEM SPECIFICATIONS
Unit: mm (in)
FUEL SYSTEM (PGM-FI) SPECIFICATIONS
COOLING SYSTEM SPECIFICATIONS
ITEM STANDARD SERVICE LIMIT
Engine oil capacity After draining 1.2 liter (1.3 US qt, 1.1 lmp qt) –
After oil filter change 1.4 liter (1.5 US qt, 1.2 lmp qt) –
After disassembly 1.7 liter (1.8 US qt, 1.5 lmp qt) –
Recommended oil Honda "4-stroke motorcycle oil" or an
equivalent
API service classification: SG or higher
(except oils labeled as energy conserv-
ing on the circular API service label)
Viscosity: SAE 10W-30
JASO T 903 standard: MB
–
Oil pressure at EOP (engine oil pressure) switch 530 kPa (5.4 kgf/cm
2
, 77 psi) at 5,000
min
-1
(rpm) (80°C/176°F)
–
Oil pump rotor Tip clearance 0.15 (0.006) 0.20 (0.008)
Body clearance 0.15 – 0.22 (0.006 – 0.009) 0.35 (0.014)
Side clearance 0.02 – 0.09 (0.001 – 0.004) 0.12 (0.005)
ITEM SPECIFICATIONS
Throttle body identification number GQB4A
Engine idle speed 1,500 ± 100 min
-1
(rpm)
Throttle grip free play 2 – 6 mm (0.1 – 0.2 in)
Fuel injector resistance (at 20°C /68°F) 11 – 13 Ω
PAIR control solenoid valve resistance (at 20°C/68°F) 20 – 24 Ω
Fuel pressure at idle 294 kPa (3.0 kgf/cm
2
, 43 psi)
Fuel pump flow (at 12 V) 33.3 cm
3
(1.1 US oz, 1.2 lmp oz) minimum/10 seconds
ITEM SPECIFICATIONS
Coolant capacity Radiator and engine 1.1 liter (1.2 US qt, 1.0 lmp qt)
Reserve tank 0.2 liter (0.2 US qt, 0.2 lmp qt)
Radiator cap relief pressure 108 – 137 kPa (1.1 – 1.4 kgf/cm
2
, 16 – 20 psi)
Thermostat Begin to open 80 – 84 °C (176 – 183 °F)
Fully open 95 °C (203 °F)
Valve lift 4.5 mm (0.18 in) minimum
Standard coolant concentration 1:1 mixture with distilled water
To Next Page
Loading...
Need help?
General
