Honda SH300 2009 User Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
3-15
EXHAUST PIPE/MUFFLER
Remove the maintenance lid (page 3-4).
Remove the two special bolts and exhaust pipe pro-
tector.
Loosen the exhaust pipe band bolt.
Remove the two exhaust pipe joint nuts.
Remove the three bolts and exhaust pipe/muffler
then remove the gasket.
Separate the exhaust pipe and muffler, then remove
the gasket.
Installation is in the reverse order of removal.
When removing the exhaust pipe stud bolts, tighten
them to the specified torque.
Check that the exhaust pipe stud bolt protrusion
from the cylinder head is specified length as shown.
Tighten the exhaust pipe joint nuts, exhaust pipe
band bolt and muffler mounting bolts in the
sequence as shown.
After installation, inspect the exhaust system for
leaks.
When installing the
exhaust pipe/muf-
fler, replace the
gaskets with new
ones.
TORQUE: 9 N·m (0.9 kgf·m, 6.6 lbf·ft)
SPECIFIED LENGTH: 34 mm (1.3 in)
TORQUE:
Exhaust pipe joint nut: 29 N·m (3.0 kgf·m, 21 lbf·ft)
Muffler mounting bolt: 49 N·m (5.0 kgf·m, 36 lbf·ft)
Exhaust pipe band bolt: 22 N·m (2.2 kgf·m, 16 lbf·ft)
GASKET
MUFFLER
BOLTS
GASKET
EXHAUST PIPE
JOINT NUTS
BAND BOLT
4, 5
3
6
1
2
Tightening procedure:
SPECIAL BOLTS
PROTECTOR
Stud bolt specified length:
34 mm (1.3 in)

Honda SH300 2009 Specifications

General

Brand	Honda
Model	SH300 2009
Category	Motorcycle
Language	English