Honda SH300 2009 User Manual

FUEL SYSTEM (PGM-FI)
6-72
BANK ANGLE SENSOR
REMOVAL
Turn the ignition switch "OFF".
Remove the rear fender A (page 3-7).
Disconnect the bank angle sensor 3P connector.
Remove the two screws and bank angle sensor.
INSTALLATION
Install the bank angle sensor with its “UP” mark fac-
ing up.
Install and tighten the two screws to the specified
torque.
Connect the bank angle sensor 3P connector.
Install the following:
– Rear fender A (page 3-7)
– Body cover (page 3-6)
– Grub rail (page 3-5)
– Luggage box (page 3-5)
3P CONNECTOR
BANK ANGLE
SENSOR
SCREWS
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
3P CONNECTOR
BANK ANGLE
SENSOR
SCREWS

Honda SH300 2009 Specifications

General

Brand	Honda
Model	SH300 2009
Category	Motorcycle
Language	English