FRAME/BODY PANELS/EXHAUST SYSTEM
3-7
REAR FENDER
REAR FENDER A
Remove the body cover (page 3-6).
Remove the following:
– license light 3P (black) connector
– two special bolts
– three washer bolts
– rear fender A
Installation is in the reverse order of removal.
REAR FENDER B
Remove the rear fender A (page 3-7).
Support the swingarm securely.
Remove either rear shock absorber (page 16-12).
Remove the ECM (page 6-65).
Remove the fuel pump/engine stop relays (page 6-
69) from the rear fender B.
Release the main wire harness and fuel tank over
flow hose from the guides of rear fender B.
Remove the four bolts and the rear fender B.
Installation is in the reverse order of removal.
Route the license
light wire properly
(page 1-19).
Route the wires
properly
(page 1-19).
REAR FENDER A
WASHER BOLTS
3P CONNECTOR
SPECIAL BOLTS
OVER FLOW HOSE
REAR SHOCK
ABSORBER
REAR FENDER B
BOLTS
MAIN WIRE HARNESS
GUIDES
To Next Page
Loading...
Need help?
General
