2MP/4MP Low Light WDR IP Camera User Guide
18
Configuring Streaming Settings
You can configure video streaming properties on the Setup Compression Setup Video
page.
The page is divided into two sections: Main Stream and Sub Stream. In the Sub Stream
section, two sub streams are configurable: Sub Stream 1 and Sub Stream 2. To enable a sub
stream, select one of the sub streams, and then select the Enable check box.
For each record type (General, Motion, Alarm), you can configure the encoding format,
resolution, frame rate, bit rate, and I-frame interval settings. You can also apply a custom
watermark to the main stream.
Format
In the Format box, select H.264B, H.264, H.264H, MJPEG, or H.265.
H.264 Main Profile. Uses less bandwidth than Baseline Profile at the same quality.
H.264B
Baseline Profile. Uses up to 50% less bandwidth than MPEG4 and up to 80% less
than MJPEG. Higher compression and lower quality than H.264.
H.264H
High Profile. Uses less bandwidth than Main Profile at the same quality. Lower
compression and higher quality than H.264.
MJPEG
Uses the most bandwidth but produces excellent image quality with access to
every
image in the stream.
H.265 High Efficiency Video Coding. Supports 4K resolution. Twice as efficient as H.264.
Smart Codec
Set Smart Codec to ON or OFF.
By taking reference frames and applying them to refreshed frames, Smart Codec eliminates
the need to transmit data for an unchanged image or parts of the image where there is no
To Next Page
Loading...
Need help?
General
