2MP/4MP Low Light WDR IP Camera User Guide
46
generate an alarm output after the event has ended. Enter a value between 10 and 300.
10. To send an email notification when motion is detected, select the Send Email check box.
Email settings must be configured in Setup
Network Setup SMTP (Email). See
Configuring Email Settings on page 33.
11. To take a snapshot when motion is detected, select the Snapshot check box.
Note
For the snapshot to be attached to the email notification, the
Attachment check box must be selected in Setup > Network Setup
> SMTP (Email). See Configuring Email Settings on page 33.
12. Click Save to apply the settings.
Configuring Camera Tampering Events
You can configure camera tampering event settings on the Setup Onboard Video Analytics
Video Detection Video Tampering page.
To enable camera tampering detection:
1. Select the Enable Tamper Detect and/or the Enable Defocus Detect check box(es).
2. Next to Alarm Period, click Setup. The Alarm Period window opens.
3. Set the days and times when you want the alarm function to be active, and then click Save.
4. To start recording video when a tampering event is detected, ensure that the Record check
box is selected.
5. In the Record Delay field, enter the number of seconds that the system will continue to
record video after a tampering event has ended. Enter a value between 10 and 300.
6. To generate an alarm output when a tampering event is detected, select the Alarm
Output check box and select the alarm output(s) to be activated.
7. In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after a tampering event has ended. Enter a value between 10
and 300.
8. To send an email notification when a tampering event is detected, select the Send Email
To Next Page
Loading...
Need help?
General
