Configuring Network Settings
37
Configuring 802.1X Settings
You can configure 802.1X settings on the Setup Network Setup 802.1X page.
802.1X is a port-based network access control protocol for preventing unauthorized devices
from accessing the LAN. You can set up user name and password credentials for the camera
so that it is not blocked by the network switch.
To enable 802.1X:
1. Select the Enable check box.
2. In the User Name field, enter the user name that will be used to authenticate the camera.
3. In the Password field, enter the password that will be used to authenticate the camera.
4. Click Save to apply the settings.
Configuring QoS Settings
You can configure Quality of Service (QoS) settings on the Setup Network Setup QoS
page.
QoS settings control bandwidth use by prioritizing certain data packets over others.
To enable QoS:
1. In the Realtime Monitor field, enter a DSCP (Differentiated Services Codepoint) value for
live video packets. Select a value between 0 (lowest priority) and 63 (highest priority).
2. In the Command field, enter a DSCP (Differentiated Services Codepoint) value for non-
video packets. Select a value between 0 (lowest priority) and 63 (highest priority).
3. Click Save to apply the settings.
To Next Page
Loading...
Need help?
General
