Configuring Event Settings
51
Note
For the snapshot to be attached to the email notification, the
Attachment check box must be selected in Setup
Network Setup
SMTP (Email). See Configuring Email Settings on page 33.
13.
Click Save to apply the settings.
Configuring Face Detection Events
You can configure face detection event settings on the Setup ïƒ Onboard Video Analytics ïƒ
Face Detection page.
To enable face detection:
1.
Select the Enable check box.
2.
Click Draw Target to set up the face detection area. You can move or resize the area using
your mouse. To move the area, drag one of the sides. To resize the area, drag one of the
corner handles.
3.
Next to Alarm Period, click Setup. The Alarm Period window opens.
4.
Set the days and times when you want the alarm function to be active, and then click Save.
5.
To enable face enhancement, select the Enable Face Enhancement check box.
6.
To start recording video when an event is detected, select the Record check box.
7.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
8.
To generate an alarm output when an event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
9.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
To Next Page
Loading...
Need help?
General
