Configuring Network Settings
29
By default, the maximum number of simultaneous connections the camera will support is set
to 10. To change this setting, in the Max Connections field, enter a value between 1 and 20.
If you want, you can change the TCP, UDP, HTTP, RTSP, and HTTPS port numbers from their
defaults.
Click Save to apply the settings.
Configuring ONVIF
ONVIF (Open Network Video Interface Forum) is a global standard for the interoperability of
IP-based physical security products.
You can enable or disable ONVIF authentication on the Setup Network Setup
Connection
ONVIF page.
ONVIF login authentication is enabled by default. To disable it, select OFF, and then click
Save.
Note
HTTPS is enabled by default. If your headend only supports ONVIF
HTTP, you can disable HTTPS by clearing the HTTPS Setting check
box and then clicking Save. A warning message will appear
indicating that your connection is no longer secure.
Configuring RSTP
RTSP Over TLS is used to encrypt video stream transmit between browser and device or
device and headend.
To Next Page
Loading...
Need help?
General
