NFS2-3030 Programming Manual — P/N 52545:K1 03/20/2012 149
Appendix I: Regional Settings
The panel programming REGIONAL SETTINGS choices, available through the Panel Settings (2)
screen (refer to page 22) are described below. The REGI
ONAL SETTINGS screen (Refer to
Figure I.1) allows scrolling through the available choices by pressing the soft key. Choices are
CHICAGO, SINGAPORE, AUSTRALIA, CHINA or DEFAULT (no special regional settings).
Figure I.1 Regional Settings Screen
I.1 Singapore
The REGIONAL SETTING choice of SINGAPORE activates the following features:
• Does not allow the disabling of a bell circuit either locally or via the network.
• A BELL CIRCUIT Type Code will allow power monitoring.
• The panel will sound the piezo when local control is set to OFF.
• Does not turn ON the System Trouble LED or the System Trouble relay for disabled points.
• Does not turn ON the System Trouble LED, the System Tr
ouble relay, or the piezo when
Drill is initiated.
• Turns ON keypad LEDs, PCB LEDs, and all ACM-24/48 LEDs
during Lamp Test.
• Requires the user to initiate the start of the applicati
on when the panel boots/reboots. The
CPU Failure LED will be ON until the user initiates startup. (Refer to Figure I.2.)
Figure I.2 Singapore Application Initiation
REGIONAL SETTINGS
REGIONAL SETTINGS:SINGAPORE
TROUBLE
LOADING..NO SERVICE
LAKEVIEW GENERAL HOSPITAL
N083
BOOTLOADER
11:58:45A WED NOV 22, 2006
CPU HAS REBOOTED
CONTINUE ABORT
User should select CONTINUE to initiate applications.
User should select ABORT to abort applications.
To Next Page
Loading...
Need help?
General
