Honeywell VOYAGER 1202G BF User Manual

2 - 22
<F0> Break Character
When your keyboard detects that any key is being pressed, released, or held down, the keyboard sends a packet of infor-
mation known as a “scan code” to your computer. There are two different types of scan codes: “make codes” and “break
codes.” A make code is sent when a key is pressed or held down. A break code is sent when a key is released. The fol-
lowing selections allow you to suppress or transmit the F0 character sequence of the break code. Default = Transmit.
Keyboard Wedge Defaults
If you want the custom keyboard wedge default settings restored to your scanner, scan the Keyboard Wedge Defaults bar
code below. This resets the scanner to the custom default settings (see Setting Custom Defaults on page 1-6). If there are
no custom defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified
through the custom defaults will be defaulted to the factory default settings.
Suppress
* Transmit
Keyboard Wedge Defaults

Honeywell VOYAGER 1202G BF Specifications

General

Product Name	Honeywell VOYAGER 1202G BF
Category	Barcode Reader
Scanner Type	Laser
Battery-Free Technology	Yes
Scan Rate	100 scans per second
Decode Capability	1D Barcodes
Interface	USB, Keyboard Wedge, RS232, IBM 46xx (RS485)
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Weight	180g (6.3 oz)
Dimensions	180 mm x 66 mm x 92 mm (7.1 in x 2.6 in x 3.6 in)
Connectivity	Bluetooth
Radio Range	Up to 10 meters
Scan Pattern	Single Line
Humidity	5% to 95% relative humidity, non-condensing
Drop Specification	Withstands 30 drops to concrete from 1.5 m (5 ft)
Power Source	Battery-Free with Supercapacitor
Resolution	1D: 4 mil (0.102 mm), 2D: 6.7 mil (0.169mm)