Honeywell Voyager 1470g User Manual

Voyager XP User Guide 87
Deactivation Character
This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the ASCII Conversion Chart (Code Page 1252), find the hex value
that represents the character you want to use to terminate scanning. Scan the fol-
lowing barcode, then use the Programming Chart to read the alphanumeric combi-
nation that represents that ASCII character. Scan Save to finish.
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights Off
barcode. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using Aimer
Mode
.
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the trigger is pulled
and when the picture is taken. During the delay time, the aiming light will appear,
but the LEDs won’t turn on until the delay time is over. Default = Off.
Deactivation Character
* Lights On
Lights Off
200 milliseconds
400 milliseconds

Honeywell Voyager 1470g Specifications

General

Brand	Honeywell
Model	Voyager 1470g
Category	Scanner
Language	English