Honeywell Voyager 1470g User Manual

16 Voyager XP User Guide
Remote MasterMind™ for USB
When using a USB interface, you may wish to configure your scanner to
communicate with Remote MasterMind Scanner Management Software (ReM).
Scan the ReM On barcode to communicate with ReM. To disable this capability,
scan ReM Off. Default = ReM On.
Note: Remote MasterMind settings apply only to the Voyager XP 1470g. They are not
supported by the Voyager XP 1472g.
Verifone
®
Ruby Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Verifone Ruby
terminal. This barcode sets the baud rate to 1200 bps and the data format to 8 data
bits, mark parity bit, 1 stop bit. It also adds a line feed (LF) suffix and programs the
following prefixes for each symbology:
ReM Off
* ReM On
Symbology Prefix
UPC-A A
UPC-E A
EAN-8 FF
EAN-13 F
Verifone Ruby Settings

Honeywell Voyager 1470g Specifications

General

Operating Temperature	0°C to 50°C (32°F to 122°F)
Environmental Sealing	IP40
Motion Tolerance	Up to 70 cm/s (27.6 in/s) for 13 mil UPC at optimal focus
Storage Temperature	-40°C to 60°C (-40°F to 140°F)
Weight	130 g (4.6 oz)
Humidity	0% to 95% relative humidity, non-condensing
Scan Pattern	Omnidirectional
Connectivity	USB, RS-232, Keyboard Wedge
Decode Capability	Reads standard 1D
Drop Specification	Withstands multiple 1.5 m (5 ft) drops to concrete
Light Levels	0 to 100, 000 lux
Dimensions	62 mm x 169 mm x 82 mm (2.5 in x 6.6 in x 3.2 in)
Light Source	LED