Voyager XP User Guide 41
range and you scan a barcode, the scanner issues an error tone indicating no com-
munication with the base or Access Point. A cordless charge base can also sound
an alarm. Refer to Out-of-Range Alarm.
Scanner Is Moved Back Into Range
The scanner relinks if the scanner or the base or Access Point have been reset, or
the scanner comes back into range. If the scanner relinks, you will hear a single
chirp when the relinking process (uploading of the parameter table) is complete.
Refer to Out-of-Range Alarm for further information.
Out of Range and Back into Range with Batch Mode On
The scanner may store a number of symbols (approximately 5000 U.P.C. symbols;
others may vary) when it is out of range and then send them to the base or Access
Point when back in range (see Batch Mode).
You will not hear a communication error tone in this mode, but you will hear a short
buzz when you pull the trigger if the radio communication is not working. Once the
radio connection is made, the scanner produces a series of beeps while the data is
being transferred to the base or Access Point.
Page Button
When you press the Page button on the base or Access Point, the scanners associ-
ated with that base or Access Point will begin beeping (3 short and 1 long beep). If
you pull the trigger on a scanner that is beeping in response, or press the Page but-
ton on the base or Access Point a second time, all associated scanners will stop
beeping. See Page for further information about Page Button settings.
About the Battery
Power is supplied to the cordless scanner by a rechargeable battery that is inte-
grated in the scanner handle. Batteries are shipped approximately 30% to 60%
charged. The battery should be charged for a minimum of 4 hours before initial use
to ensure optimal performance.
Warning: There is a danger of explosion if the batteries are incorrectly
replaced. Replace the batteries with only the same or
equivalent type recommended by the manufacturer. Dispose of
used batteries according to the recycle program for batteries as
directed by the governing agency for the country where the
batteries are to be discarded.