12 Power-on and Commissioning
12.1 Connecting the Reused DG Supply
Prerequisites
Sparks, ames, and inammable objects must not be close to a DG because this
may cause re or explosions.
Check according to the following table before powering on and commissioning the
DG.
Table 12-1 Power-on check
Item
Expected Result
Appearance ● No engine oil leaks.
● No fuel leaks.
● No coolant leaks.
● No component is damaged or lost.
● No fastener is loose, lost, or damaged.
● No component is cracked, worn out, or damaged, and no connector is
damaged or corroded.
● The EMERGENCY STOP button is in the self-lock state, and the load circuit
breaker is in a proper position.
● No hose is cracked, worn out, damaged, or stuck.
● No water or impurities exist in the fuel
lter. Remove any water and
impurities.
Fuel, lube oil, and
coolant
Levels of fuel, lube oil, and engine coolant are within the normal range.
PowerCube 1000 (STC, Saudi Arabia, ICC800-A1-C2,
ESC800-A1)
Installation Guide 12 Power-on and Commissioning
Issue 02 (2021-09-28) Copyright © Huawei Technologies Co., Ltd. 121
To Next Page
Loading...
Need help?
General