IBM 6400 Maintenance Information Manual

IBM Coax/Twinax Expansion Board
215
IBM Coax/Twinax Expansion Board
Removal
ATTENTION
To prevent electrostatic damage to electronic components, wear a
properly grounded static wrist strap when handling circuit boards, the
shuttle frame assembly, and any other electronic component.
1. Prepare the printer for maintenance (page 152).
2. Cabinet Model: Remove the paper guide assembly (page 229).
Pedestal Model: Remove the top cover assembly (page 204).
3. Loosen, but do not remove, the two screws securing the coax/twinax I/O
plate to the rear of the card cage. Loosen the thumbscrew on the CT
board until the screw is released from the standoff on the controller board.
(See Figure 54, page 282.)
4. Carefully lift the expansion-CT board out of the card cage cutout and off
the expansion connector adapter that attaches the CT to the CMX board.
5. Remove the expansion connector adapter from the CMX controller board
by carefully lifting it straight up and out of the controller connector.
Installation
1. Reverse steps 2 through 5 of the removal procedure.
2. Return the printer to normal operation (page 153).

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English