341
E Safety Inspection Guide
Safety Inspections
Safety devices to protect customers, operators, and service personnel from
injury are installed in all IBM 6400 printers. Use this inspection guide as an aid
in identifying possible unsafe conditions in a 6400 series printer.
Perform the inspection steps outlined in this guide before the normal
inspection for Maintenance Agreement Qualification, or any time you are
instructed to make a safety inspection.
If you find any unsafe conditions, determine the severity of the hazard and
whether or not you can continue the inspection without first correcting the
problem.
NOTE: The correction of any unsafe condition is the customer’s
responsibility.
Preparation
You must have completed the “Electrical Safety Training Course for IBM
Customer Engineers” (self-study course 77170 or existing level) to do the
Safety Inspection.
Have the following items available:
•
Electrical Safety for IBM Customer Engineers
, Order No. S229-8124.
• A Fluke** meter (P/N 8496278) or similar device for resistance and
voltage measurements.
• An ECOS** Electrical Safety Tester (P/N 6339695) in the United States or
a similar safety tester in other countries.
For each safety check on the following pages, do the steps in the order
presented. Do not omit any steps.
To Next Page
Loading...
Need help?
General