Shaft, Support
241
Shaft, Support
Removal
1. Prepare the printer for maintenance (page 152).
2. Open the printer cover.
3. Unlock the tractors and slide them to the far right.
4. Remove the paper supports from the splined shaft and support shaft.
(See Figure 50, page 274, item 21.)
5. Remove the E-ring (page 274, Figure 50).
ATTENTION
Hold the tractors while removing the support shaft, and be careful not to
lose the curved spring washers. (See Figure 50, page 274, item 5.)
6.
Slide the support shaft assembly—consisting of the support shaft, two
curved washers, bushing, horizontal adjustment knob, washer and
screw—to the left, out of the tractors and the left side plate.
Installation
1.
Slide the support shaft assembly—consisting of the support shaft, two
curved washers, bushing, horizontal adjustment knob, washer, and
screw—into the left side plate. (See Figure 50, page 274.)
2.
Slide the tractors onto the support shaft.
3.
Slide the support shaft assembly through the right side plate.
4.
While pushing on the knob to compress the curved washers, install the
E-ring in the groove on the bushing.
5.
Install the paper supports on the splined shaft and support shaft. (See
Figure 50, page 274, item 21.)
6.
Return the printer to normal operation (page 153).
To Next Page
Loading...
Need help?
General