Starting the Test
1. Press 1 (RUN TESTS MULTIPLE TIMES), then
Enter.
2. Select the device you suspect has a failure, then
press Enter.
3. Select the number of times the test is to be run; then
press Enter.
4. Press N (WAIT EACH TIME AN ERROR OCCURS
(Y/N)?), then Enter.
5. Follow any instructions on the display and select all
available tests.
Note: Do not press any keys during the keyboard
test.
6. To end (RUN TEST CONTINUOUSLY), press and
hold the Ctrl key; then press the Pause key. The
computer will complete testing and return to the
Installed Devices menu.
Display the Error Log
1. Depending on the options installed in the computer,
questions about attached devices will appear on the
display. Answer as required; then press Enter.
2. Press Y or N (IS THE LIST CORRECT (Y/N)?), then
Enter.
3. Press 2 (LOG UTILITIES), then Enter.
4. Press 2 (DISPLAY LOG), then Enter.
5. Press A (ENTER THE DRIVE ID FOR ERROR
LOG?), then Enter.
6. If no errors occurred, the Log Utilities menu appears.
If errors are displayed, go to “Symptom-to-FRU Index”
on page 237.
Setup Options
The computer has two setup options that allow you to
specify how the computer operates. The System
Parameters (Ctrl+Alt+F3) provides access to the power
management parameters and the following system
elements.
Time
Date
Password
Diskette drive
Hard disk drive
Cache
Parallel port
Starting Setup
Press the key combination for the setup program you want
to start.
244 IBM Mobile Systems HMM - Volume 1
To Next Page
Loading...
Need help?
General