IBM N51 Series User Manual

014 (continued)
IS THE CONFIGURATION THE SAME AS THE
INSTALLED DEVICES?
Yes No
015
– Go to “Checking the Installed Devices” on
page 397.
016
– Select Start and press Enter.
Diagnostic tests will run on all available devices.
If the test finds a device error, the error is displayed with
an X beside the device name.
For example:
DID THE TESTS FIND A DEVICE ERROR?
Yes No
017
The error was not detected by the basic test. Go to
Step 019.
018
– Note the error codes and go to “FRU Codes” on
page 419 and replace the appropriate FRUs.
019
– Go to the advanced diagnostic screen by pressing
Ctrl+A, and run the following tests.
 Diskette drive test (use a blank diskette).
 Serial port test (with the wrap plug).
Note: Install the wrap plug on the serial port of
Dock II.
 Parallel port test (with the wrap plug).
Note: Install the wrap plug on the parallel port of
Dock II.
 PCMCIA-2 test (with the PC test card).
Note: Install the PC Test Cards into the PCMCIA
slot of Dock II.
(Step 019 continues)
SystemBoard
02
FRU
0010
DEV 001
ERR
DEV: Device ID
ERR: Error Description Code
FRU: FRU Code
Note: If the test stops or hangs during
the test, replace the last device
that was tested.
Dock II (3546) 395

IBM N51 Series Specifications

General

Brand	IBM
Model	N51 Series
Category	Laptop
Language	English