76
5
FUNCTIONS FOR RECEIVE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ Noise Blanker
(Mode: SSB/CW/RTTY/AM
)
The Noise Blanker eliminates pulse-type noise such
as noise from car ignitions.
➥ Push [NB] to turn the Noise Blanker function ON or
OFF.
•
“NB” is displayed when the
Noise Blanker
is ON.
When using the Noise Blanker function, received
signals may be distorted if they are excessively
strong or when used for noise other than pulses. In
this case, set the Noise Blanker threshold level to a
shallow position, or turn OFF the function. (see
below)
■ Meter peak hold function
When the “Meter Peak Hold” item is set to ON in the
Set mode, the peak level of a received signal strength
or the output power is displayed for approximately 0.5
seconds. (p. 162)
D NB Set mode
To deal with various types of noise, the attenuation
level and noise blanking duration can be set in the NB
set mode.
q Hold down [NB] for 1 second to display the “NB”
screen (Noise blanker).
w Push [Y](F-1) or [Z](F-2) to select the desired
item.
e Rotate [MAIN DIAL] to select the desired option.
•Holddown[F-3]for1secondtoresettothedefaultset-
ting, if desired.
r Push [
NB
] to save, and
return to the previous
screen.
Appears
NB Level 1. (Default: 50%)
Setthenoiseblankerthresholdleveltobetween0%
and100%.
NB Depth 2. (Default: 8)
Set the noise attenuation level to between 1 and 10.
NB Width 3. (Default: 50)
Set the blanking duration to between 1 and 100.
Select the item
Select a default
setting
Ù 11 Ú ON
SET Meter Peak Hold
Appears for 0.5 seconds.
To Next Page
Loading...
Need help?
General
