80
6
FUNCTIONS FOR TRANSMIT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ Speech compressor
(Mode: SSB
)
The Speech Compressor function increases average
RF output power, improving signal strength and read-
ability.
q Push [SSB] to select the USB or LSB mode.
w Adjust the [MIC GAIN] control so that the ALC
meter reads within the ALC zone, whether or not
you speak softly or loudly.
e
Push [MENU] to display the “M1” screen (Menu 1),
then push [COMP](F-3) to turn ON the Speech Com-
pressor.
r Hold down [COMP](F-3) for 1 second to display the
“COMP” screen (Compressor).
t While speaking into the microphone at your normal
voice level, rotate [MAIN DIAL] so the COMP meter
reads within the COMP zone.
•Holddown[F-3]for1secondtoresettothedefaultset-
ting, if desired.
When the COMP meter peaks above the COMP
level zone, your transmitted voice may be dis-
torted.
y Push [MENU] to return to the previous menu.
■
Transmit lter width selection
(Mode: SSB
)
The transmit filter width for the SSB mode can be se-
lected from Wide, Mid or Narrow.
q Push [SSB] to select the USB or LSB mode.
w
P
ush [MENU] to display the “M1” screen (Menu
1), then hold down [TBW](F-4) for 1 second, one
or more times, to select a Wide, Mid or Narrow
transmission passband width.
•Push[TBW](F-4)momentarilytodisplaytheselected
TX filter width for approximately 1 second.
•Thefollowingltersarespeciedasthedefaults.Each
of the filter widths can be set in the Tone control Set
mode. (pp. 169, 170)
- WIDE : 100 Hz to 2900 Hz
- MID : 300 Hz to 2700 Hz
- NAR : 500 Hz to 2500 Hz
Appears
Shows the compression level
COMP level zone
COMP meter
DUPAGC COMP TBW SCP
M1
DUPAGC COMP TBW SCP
M1
TBW WIDE
Hold down
The selected transmit filter width is
displayed for approximately 1 second.
[SSB]
[COMP]
[MAIN DIAL]
[MENU]
[MIC GAIN]
To Next Page
Loading...
Need help?
General
