– 102 –
5-4-3. Changing the feed locus
Name Characteristics
Standard
height
Image of oper-
ation
Stitch length and sewing speed
M
Goes up straight and comes down
straight.
This feed locus provides the gener-
al-purpose timing.
1.3 mm
0 to 4.00 mm : 5,000 sti/min
4.05 to 5.00 mm : 4,000 sti/min
S
The feed timing of this locus is
earlier than the other settings.
This feed locus is suitable for light-
weight materials.
1.3 mm 0 to 5.00 mm : 4,000 sti/min
H
The feed timing of this locus is later
than the other settings. This feed
locus permits easy formation of
angular shapes of zigzag stitches.
1.3 mm 0 to 5.00 mm : 4,000 sti/min
NU
This feed locus is suitable for
stretch materials since it reduces
slippage between materials.
Use this feed locus since backward
feed is likely to occur.
1.3 mm 0 to 5.00 mm : 2,500 sti/min
2) Display "S068 Feed locus" by pressing
.
The feed locus can be changed according to the
item to be sewn.
[How to change]
1) Display the sewing data edit screen bypress-
ing
.
3) Change the feed locus.
* Refer to the following for the types of feed-
locus.
4) Conrm your entry by pressing
.
5) Display the sewing screen by pressing
.
To Next Page
Loading...
Need help?
General
