– 9 –
Power indication tag
(For example : In the case of 200V)
2-11-2. Connecting the power source cord
Voltage specications at the time of delivery from the factory are indicated on the voltage indication seal.
Connect the cord in accordance with the specications.
• Connecting 3-phase 200 to 240V
• Connecting single phase 220 to 240V
• Connecting single phase 100 to 120V
AC200 to 240V
Light blue
Red
Green/Yellow
Green/Yellow
Green/Yellow
Green/Yellow
Table
Table
Control box
Control box
Power switch
Power switch
Brown
White
White
Green/Yellow — GND
White
Black
Red
Black
Green/Yellow
Green/Yellow
Power switch
Control box
Table
White
White
White
Black
Black
Green/Yellow — GND
AC220 to 240V
White
Black
Never use under the wrong voltage and phase.
Rating plate
Black
Red
Red
Black
2-12. Installing the accessory ring core (Only for the EU type models)
2-12-1. Installing the accessory ring core supplied with the electrical box
Refer to accessory manual for "Installing the accessory ring core" supplied with the electrical box for how to
install the ring core.
After screwing the cable to the
power switch, bind the cable
sheath portion with an acces-
sory clip band inside the power
switch.
To Next Page
Loading...
Need help?
General
