DC Power Grounding Requirements and Warning
An insulated grounding conductor that is idencal in size to the grounded and ungrounded branch
circuit supply conductors but is idenable by green and yellow stripes is installed as part of the branch
circuit that supplies the device. The grounding conductor is a separately derived system at the supply
transformer or motor generator set.
WARNING: When you install the device, the ground connecon must always be made
rst and disconnected last.
Waarschuwing Bij de installae van het toestel moet de aardverbinding aljd het eerste
worden gemaakt en het laatste worden losgemaakt.
Varoitus Laitea asenneaessa on maahan yhdistäminen aina tehtävä ensiksi ja
maadoituksen ir kytkeminen viimeiseksi.
Averssement Lors de l'installaon de l'appareil, la mise à la terre doit toujours être
connectée en premier et déconnectée en dernier.
Warnung Der Erdanschluß muß bei der Installaon der Einheit immer zuerst hergestellt
und zuletzt abgetrennt werden.
Avvertenza In fase di installazione dell'unità, eseguire sempre per primo il collegamento
a massa e disconneerlo per ulmo.
Advarsel Når enheten installeres, må jordledningen alld lkobles først og frakobles sist.
Aviso Ao instalar a unidade, a ligação à terra deverá ser sempre a primeira a ser ligada, e
a úlma a ser desligada.
¡Atención! Al instalar el equipo, conectar la erra la primera y desconectarla la úlma.
Varning! Vid installaon av enheten måste jordledningen alld anslutas först och
kopplas bort sist.
DC Power Wiring Sequence Warning
WARNING: Wire the DC power supply using the appropriate lugs. When connecng
power, the proper wiring sequence is ground to ground, +RTN to +RTN, then –48 V to –
294
To Next Page
Loading...
Need help?
General
