Juniper EX2300 Series Hardware Guide

• If you are mounng an EX2300 switch in a rack or cabinet with other equipment, or if you are placing
it on or under a desk or oor near other equipment, ensure that the exhaust from other equipment
does not blow into the intake vents of the chassis.
NOTE: You can mount only EX2300-C switches under a desk or other level surface.
• Leave at least 24 in. (61 cm) in front of the switch and 6 in. (15.2 cm) behind the switch. For service
personnel to remove and install hardware components, you must leave adequate space at the front
and back of the switch. NEBS GR-63 recommends that you allow at least 30 in. (76.2 cm) in front of
the rack or cabinet and 24 in. (61 cm) behind the rack or cabinet.
EX2300 Network Cable and Transceiver Planning
IN THIS SECTION
Pluggable Transceivers Supported on EX2300 Switches | 75
SFP+ Direct Aach Copper Cables for EX Series Switches | 77
Understanding EX Series Switches Fiber-Opc Cable Signal Loss, Aenuaon, and Dispersion | 79
Calculang the Fiber-Opc Cable Power Budget for EX Series Devices | 81
Calculang the Fiber-Opc Cable Power Margin for EX Series Devices | 81
Pluggable Transceivers Supported on EX2300 Switches
You can nd the list of transceivers supported on EX2300 switches except EX2300-24MP and
EX2300-48MP and informaon about those transceivers at the Hardware Compability Tool page for
EX2300.
You can nd the list of transceivers supported on EX2300-24MP and EX2300-48MP switches and
informaon about those transceivers at the Hardware Compability Tool page for EX2300 Mulgigabit.
75

Juniper EX2300 Series Specifications

General

Brand	Juniper
Model	EX2300 Series
Category	Switch
Language	English