Juniper SRX220 User Manual

Figure 17: Connecting the SRX220 Services Gateway to the Power Supply
g037611
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Before the servicesgateway is fullyconfigured and running, you might
hear a crackling noise from the power supply unit. This noise is temporary
and stops after the device is configured.
Related
Documentation
Required Tools and Parts for Installing and Maintaining the SRX220 Services Gateway
on page 72
•
• Grounding the SRX220 Services Gateway on page 93
• Connecting and Organizing Interface Cables for the SRX220 Services Gateway on
page 92
• SRX220 Services Gateway General Safety Guidelines and Warnings on page 51
Connecting and Organizing Interface Cables for the SRX220 Services Gateway
You can connect the interfaces installed in the services gateway to various network
media. Each type of interface on the services gateway uses a particular medium to
transmit data. You must configure each network interface before it can operate on the
device.
To connect and organize an interface cable for the device:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable connector port on the interface faceplate.
3. Arrange network cables as follows to prevent them from dislodging or developing
stress points:
Copyright © 2012, Juniper Networks, Inc.92
SRX220 Services Gateway Hardware

Juniper SRX220 Specifications

General

Brand	Juniper
Model	SRX220
Category	Gateway
Language	English