NOTE: To remove power completely from the device, unplug the AC power
cord or switch off the power source.
After powering off a power supply, wait at least 10 seconds before turning
it back on. After powering on a power supply, wait at least 10 seconds
before turning it off.
The Power button on the services gateway is a standby power switch.
If you press the Power button to power off the device when it is still
connected to a power source, 12 V (SRX220H model) or 48 V
(SRX220H-POE model) power will still be available in the chassis and the
device will be fully powered off.
TIP: When you are powering off the device, the system displays the following
message: Turning the system power off. You can now safely remove the
power cable to completely disconnect the power from the device.
NOTE: You can use the request system reboot command on the CLI to
schedule a reboot of the services gateway.
For more information about halting, powering off, or rebooting the services gateway using
the CLI, see the Junos OS Administration Guide for Security Devices
Resetting the SRX220 Services Gateway
The Reset Config button located at the front panel of the services gateway resets the
device configuration in either of two ways:
•
Pressing the Reset Config button briefly reverts the device configuration to the
configuration in use when the device was last started.
•
Pressing and holding the Reset Config button for 15 seconds or more deletes all
configurations on the device and loads and commits the factory configuration.
The button is recessed in the front panel to prevent it from being pressed accidentally.
Related
Documentation
Connecting the SRX220 Services Gateway to the Power Supply on page 91•
• Grounding the SRX220 Services Gateway on page 93
• SRX220 Services Gateway Front Panel and Back Panel Views on page 9
• Using the Reset Config Button on the SRX220 Services Gateway on page 135
Copyright © 2012, Juniper Networks, Inc.96
SRX220 Services Gateway Hardware
To Next Page
Loading...
Need help?
General
