CHAPTER 16
Configuring Basic Settings
•
SRX220 Services Gateway Software Configuration Overview on page 109
•
Performing Initial Software Configuration on the SRX220 Services Gateway Using the
CLI on page 113
•
Performing Initial Software Configuration on the SRX220 Services Gateway Using the
J-Web Interface Setup Wizard on page 115
SRX220 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX220 Services Gateway for Configuration on page 109
•
Understanding the Factory Default Configuration on page 110
•
Understanding Built-In Ethernet Ports and Initial Configuration on page 110
•
Mapping the Chassis Cluster Ports on page 111
•
Understanding Management Access on page 112
Preparing the SRX220 Services Gateway for Configuration
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled and ready to be configured when the device is powered on.
When the device powers on, it tries to start the Junos OS on the USB flash drive. If a USB
flash drive is not inserted into the USB connector or if the attempt otherwise fails, the
device next tries the CompactFlash card, and finally the internal flash memory.
You can perform the initial software configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the device, gather the configuration information required to deploy
the device in your network. At minimum, the setup wizard requires the following
information:
•
Device name to be used on the network
•
Password for the root user
•
Time information for the services gateway location:
109Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
