.
MAINTENANCE
SERVICE PROCEDURE
CHANGE OIL IN FINAL DRIVE CASE
WARNING
The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the
operation.
Oil replacement amount: 58 liters (15.31 US gal)
1.
Stop the machine so that drain plug (3) is directly at the bottom.
2. Remove oil level plug (2) and oil filler plug (1), then remove
drain plugs (3) and (4) and drain the oil. After draining the oil,
tighten the plugs.
3. Add engine oil to the specified level through the hole in oil filler
plug (1).
4.
After filling with oil, check that the oil is at the specified level.
For details, see "CHECK OIL LEVEL IN FINAL DRIVE CASE,
ADD OIL (PAGE 4-47)".
WASH POWER TRAIN CASE BREATHER
Remove the breather, then wash it in clean diesel oil or flushing oil
to rinse the dirt out from inside.
Power train case breather (1 place)
Remove inspection cover (2) at the bottom right of the operator's
seat. The breather (1) is installed on the right side of the window
(rear of machine).
4 - 61
To Next Page
Loading...
Need help?
General
