.
SAFETY
PRECAUTIONS FOR OPERATION
PARKING MACHINE
Park the machine on level ground where there is no danger of
falling rocks or landslides, or of flooding if the land is low, and
lower the work equipment to the ground.
If it is necessary to park the machine on a slope, set the blocks
under the tracks to prevent the machine from moving, then dig
the work equipment into the ground.
After stopping the engine, operate the right work equipment
control lever several times to the RAISE and LOWER positions
to release the remaining pressure in the hydraulic circuit.
When parking the machine on a road, put up flags, fences, lighting, or warning signs to enable passing vehicles
to recognize the machine clearly. At the same time, make sure that these do not cause obstruction to the passing
vehicles.
Procedure for parking: See "PARKING MACHINE (PAGE 3-108)".
When leaving the machine, set the safety lock levers (for work equipment and brake) to the LOCK position, and
then stop the engine. In addition, use the key to lock all the equipment. Always remove the key and take it with
you to be kept at a set location.
Work equipment posture: See PARKING MACHINE (PAGE 3-108)
Locks: See LOCKING (PAGE 3-110)
Always close the door of the operator's compartment.
2 - 24
To Next Page
Loading...
Need help?
General
