.
MAINTENANCE
SERVICE PROCEDURE
EVERY 2000 HOURS SERVICE
Maintenance for every 250, 500, and 1000 hours should be performed at the same time.
CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAURIC OIL FILTER ELEMENT
WARNING
The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before changing the
oil.
When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully.
Oil replacement amount: 87 liters (22.99 US gal)
1. Lower the blade and the ripper completely to the ground, and
stop the engine. Turn the cap of oil filler port (F) slowly to
release the internal pressure, then remove the cap.
2. Remove plug (1) at the bottom of the hydraulic tank, loosen
drain valve (2), and drain the oil. After draining the oil, tighten
drain valve (2) and plug (1). When loosening and drain valve
(2), be careful not to get oil over yourself.
3.
Tighten mounting bolts (5) of inspection cover (4) of the cover
at the front of the hydraulic tank, then remove the inspection
cover.
4 - 67
To Next Page
Loading...
Need help?
General
