TROUBLESHOOTING 22
247
Faults Possible cause Action
The combination instrument
shows nothing on the display
Fuse 1 is blown – Change the fuses in the fuse box.
( p. 202)
The main fuse is blown – Change the main fuse. ( p. 200)
The battery is discharged – Recharge the battery. ( p. 195)
– Check the open-circuit current.
The ignition/steering lock is
faulty
– Check the ignition/steering lock.
The engine does not crank
when the electric starter but-
ton is pressed
The emergency OFF switch is
off
– Press the emergency OFF switch to the
position ON .
Operating error – Carry out the start procedure.
( p. 103)
The battery is discharged – Recharge the battery. ( p. 195)
– Check the open-circuit current.
The safety start system is faulty – Read out the fault memory using the
KTM diagnostics tool.
CAN bus communication error – Read out the fault memory using the
KTM diagnostics tool.
Fault in the engine electronics
control unit.
– Read out the fault memory using the
KTM diagnostics tool.
Fault in the MCU control unit. – Read out the fault memory using the
KTM diagnostics tool.
To Next Page
Loading...
Need help?
General
