24 DECLARATIONS OF CONFORMITY
168
24.1 Declarations of conformity
Info
The functional and equipment scope is model-dependent and may not include all wireless systems and
application areas referred to.
252M1100
FCC ID: Z64‑2564N
IC: 4511‑2564N
Immo641
FCC ID: 2AKP9IMMO641
IC: 22273-IMMO641
Tyre Pressure Monitoring System ‑ Receiver "MC34MA4"
FCC ID: MRXMC34MA4
IC: 2546A-MC34MA4
Tyre Pressure Monitoring System ‑ Sensor "BC5A4"
FCC ID: MRXBC5A4
IC: 2546A-BC5A4
Declaration regarding modifications
Alterations and modifications not expressly approved by the relevant authority may result in the user being prohib-
ited from operating the equipment.
Declaration regarding interference
This device fulfills Part 15 of the FCC regulations as well as the license-free RSS standards of the Canadian Gov-
ernment Department Industry Canada.
Operation is subject to the following two conditions:
1 This device must not cause interference.
2 This device must be able to absorb any interference, including interference that potentially causes undesir-
able operation of the device.
Note on radio transmissions
This device corresponds to the FCC limit values for radiation exposure, which have been determined for a non-
controlled environment, and fulfills the FCC guidelines for the load from radio frequencies.
The transmitter must not be set up near to other antennas or transmitters or operated in conjunction with other
antennas or transmitters.
Note on digital devices of Class B according to the FCC regulations
This device has been tested and fulfills the limit values for digital devices of Class B according to the FCC regula-
tions, Part 15.
These limit values are designed so as to provide sufficient protection from harmful interference in residential
areas.
Devices of this type generate and use high frequencies and can also emit these. Therefore, if they are not
installed and operated in accordance with the instructions, they may cause harmful interference to radio
reception. However, there is no guarantee that interference will not occur in certain cases of application.
Should this device cause harmful interference to radio or television reception, (check this by switching the device
on and off), you can potentially eliminate this interference as follows:
– Re-align the receiving antenna.
– Increase the separation between device and radio receiver.
– Connect the device and the radio receiver to separate electric circuits.
– Consult your dealer or a radio/TV technician.
CAN ICES‑3 (B) / NMB‑3 (B)
This digital device of Class B fulfills the regulations in accordance with the Canadian Interference-Causing Equip-
ment Standard ICES‑003 / NMB‑003.
To Next Page
Loading...
Need help?
General
