6 CONTROLS
22
– Operating the hand brake lever
– Operating the foot brake lever
– Operating the clutch lever
– Turning the throttle grip beyond the basic position
– Control of the motorcycle traction control (MTC)
– Slip at the rear wheel or lifting front wheel
– A malfunction occurring, which impairs the cruise control sys-
tem function
– Exceeding the target speed for more than 30 seconds when
overtaking
Warning
Danger of accidents The cruise control system function is
not suitable for all riding situations.
The selected target speed will not be reached, if the
engine power is not sufficient for a gradient.
The selected target speed will be exceeded if the engine
braking effect is not sufficient on an incline.
– Do not use the cruise control systems function on
winding roads.
– Do not use the cruise control systems on slippery road
surfaces (e.g. rain, ice or snow), where there is poor
visibility or on unpaved surfaces (e.g. sand, stones or
gravel).
– Do not use the cruise control systems function if the
traffic does not permit a constant speed.
The cruise control system function is only available when motorcy-
cle traction control (MTC) is activated.
When motorcycle traction control (MTC) is switched off, the cruise
control system function is also switched off.
The cruise control system function cannot be activated during
rapid acceleration.
The cruise control system function cannot be activated in first-
gear.
Control range of the
cruise control system
30 … 160 km/h (18.6 … 99.4 mph)
6.4.4 Menu buttons
I00281-10
The menu buttons are fitted in the middle of the left combination
switch.
The menu buttons are used to control the display on the combina-
tion instrument.
Button
1
is the UP button.
Button
2
is the DOWN button.
Button
3
is the SET button.
Button
4
is the BACK button.
To Next Page
Loading...
Need help?
General
