9: Setup Mode: Advanced Settings
UDS2100 Device Server User Guide 61
Disable Monitor Mode at Bootup
This option allows you to disable all entries into Monitor Mode during startup,
except for the ‘xxx’ sequence. This prevents entry using yyy, zzz, xx1, and yy1
key sequences (only during the bootup sequence). The default for Monitor Mode
at bootup is N (No). (See 11: Monitor Mode.)
Disable Monitor Mode @ bootup (N) ?
HTTP Port Number
This option allows the configuration of the web server port number. The valid
range is 1-65535. The default HTTP port number is 80.
HTTP Port Number : (80) ? _
MTU Size
The Maximum Transmission Unit (MTU) is the largest physical packet size a
network can transmit for TCP and UDP. Enter between 512 and 1400 bytes. The
default setting is 1400 bytes.
MTU Size: (512 - 1400): (1400) ?
TCP Re-Transmission Timeout
This feature allows the configuration of the desired TCP re-transmission timeout
value. If the ACK is not received for a packet sent from the UDS2100 device,
then the unit will retransmit the data. The valid range is 500-4000 msec.
TCP Re-transmission Timeout (500 – 4000) (ms): (500) ?
Enable Alternate MAC
If necessary, enable the alternate MAC address (if specified in the OEM setup
record). The default setting is N (No).
Enable alternate MAC (N) ? _
Ethernet Connection Type
The UDS2100 allows for the Ethernet speed and duplex to be manually
configured. Enter 0 for auto-negotiation (default). To select the speed and
duplex, enter one of the following: 2 (10Mbit/half duplex), 3 (10Mbit/full duplex), 4
(100Mbit/half duplex), or 5 (100Mbit/full duplex).
Ethernet connection type: (0) ? _