4. Installation MMX8x4-HT series – User's Manual 31
Control Ethernet Port
both cable types (straight or cross) are supported and handled by the device, below pin assignment is
recommended.
Wiring of LAN Cables
standards.
LED1 green
on
off
LED2 amber
on no activity
off not linked
blinking activity
Top
Bottom
Side
compliant. See more information in Ethernet Interface section.
DIFFERENCE: MMX8x4-HT400MC and MMX8x4-HT400M models have TPS connector.
Not PoE-compatible.
This model has four TPS inputs and two TPS outputs. PoE-compatible, each port can remote
INFO:
IR Connector
IR emitter can be connected to the matrix switcher with TRS (Tip, Ring, and Sleeve) connectors. They
The pin assignments are the following :
Emitter – 2-pole-TS
1 Tip
2 Ring
Signal (active low)
3 Sleeve
INFO: Ring pole of the emitter is optional. If your IR emitter has three pole- TRS plug, then the Ring and the
Sleeve are the same signal (Output - ).
INFO: Infra Interface section.
To Next Page
Loading...
Need help?
General
