Maintenance work on the carrier
7.6 Transmission
16.11.2018
Maintenance manual 3 302 756 en 7 - 49
GMK6400
7.6.5 Changing the oil and oil filter – Power take-off
Oil, spare parts
and tools
– Receptacle, about 5 l (1.5 gal); à p. 2 - 4.
– Torque wrench for a torque of 60 Nm (44.2 lbf ft).
Prerequisites – The gear oil must be at operating temperature (70 to 95 °C (160 to 200 °F)).
– The truck crane must be raised on outriggers or parked over an inspec-
tion pit.
– The truck crane must be level.
– The engine must not be running and must be secured against unauthor-
ised use; Ã p. 2 - 3.
Draining oil
s
Gear oil
in litres (gal)
Specifications
Classification
GROVE part no.
4.5 (1.2) ZF TE-ML02
Ecofluid M ZF
synthetic
03325153
Designation Quantity GROVE part no.
Seal 18 x 24 Cu DIN 7603 (drain) 1 01377793
Seal 26 x 31 Cu DIN 7603 (filler) 1 00117147
Oil filter 1 04155134
O-ring 78 x 3 1 03143694
G
Risk of scalding from gear oil at operating temperature!
You could scald yourself by gear oil escaping in an uncontrolled manner at
operating temperature. Wear appropriate protective gloves and take care
not to come into contact with the gear oil.
O
Risk of environmental damage due to leaking consumables!
Always let consumables drain into suitable receptacles. Wipe up any
consumables that escape.
Store/dispose of consumables and any soaked equipment properly.
Ask about the applicable regulations.
To Next Page
Loading...
Need help?
General
