Mitsubishi FR-E 500 User Manual

53
3.2.4 Frequency setting
In the PU operation mode, set the frequency value used for operation performed
under the operation command given by the
RUN
key (
FWD
or
REV
key).
This mode is displayed only in PU operation.
To 3.2.5 Parameter setting mode
MODE
Hz
PU
MODE SET REV
STOP
RESET
FWD
"
Frequency setting mode
"
Set frequency changing
SET
To frequency monitoring
MODE
Hz
PU
"
Set frequency
write
Flicker
Hz
PU
Hz
PU
Change the set
frequency with
3.2.5 Parameter setting method
With the exception of some parameters, parameter setting can be made only when the
PU operation mode is selected by the Pr. 79 setting.
!
A parameter value may either be set by updating its parameter number or setting
the value digit-by-digit using the
/ key.
!
To write the setting, change it and press the
SET
key for about 1.5 seconds.
Note:If parameter write cannot be performed, refer to page 177.
3

Mitsubishi FR-E 500 Specifications

General

Brand	Mitsubishi
Model	FR-E 500
Category	Inverter
Language	English