3.3 Operation
58
3.3 Operation
3.3.1 Pre-operation checks
Before starting operation, check the following:
"
Safety
Perform test operation after making sure that safety is ensured if the machine
should become out of control.
"
Machine
Make sure that the machine is free of damage.
"
Parameters
Set the parameter values to match the operating machine (system) environment.
"
Test operation
Perform test operation and make sure that the machine operates safely under light
load at a low frequency. After that, start operation.
Since the Pr. 240 "Soft-PWM setting" value is factory-set to select Soft-PWM
control, the tone is different from that in the conventional non-low acoustic noise
mode, this is not a fault.
To Next Page
Loading...
Need help?
General
