© MOOG 2019
This document is subject to MOOG INTELLECTUAL AND PROPRIETARY INFORMATION LEGEND . The details are on page II.
⑤ During ② to ④, DigiPackⅢ functions as a digital interface with the PLC of the blow molding machine
and provides information such as the end of the program and the point status of the program se-
quentially.
Successful performance of the DigiPackⅢ depends a great deal upon how well it is installed on the
machine. By following the instructions contained idatan this manual it will be possible to easily install this
system and obtain many years of trouble free operation.
1-2-2. WHO CAN INSTALL THE DigiPackⅢ
The installation of the DigiPackⅢ control system requires the installer to be familiar with electrical wiring,
hydraulic plumbing and basic metal working. The calibration and start up of the finished system requires
some understanding of the blow molding process and use of test instruments such as a digital voltmeter.
The plumbing, wiring and bracketry should not be difficult. Most molding shop maintenance men who are
familiar with blow molding machines will have little difficulty with the help of this manual.
The system can be satisfactorily calibrated to the machine and started up without assistance or special
equipment by following the instructions in this manual.
To Next Page
Loading...
Need help?
General
