© MOOG 2019
This document is subject to MOOG INTELLECTUAL AND PROPRIETARY INFORMATION LEGEND . The details are on page II.
1-2-3. INSTALLATION TIME
The time to install a DigiPackⅢ varies with the type and size of machine, mechanical constraints such
as the location of water lines and auxiliary equipment and the ability of the mechanic doing the installation.
Our experience has shown that typical maintenance men will require about 20 to 30 man hours. Smaller
machines will require less time.
Of this time, the actual machine shut down time can be held to 6 hours or less.
1-2-4. SOFTWARE UPDATE
The software of this controller may be updated if a bug is found or the function is improved. Please check
the software update status (latest version) from the MOOG website below. Also you can download the
update file "DIGIPK3.FMW" from the website. How to update Please refer to the following description.
Update Process
1. Prepare the USB memory and turn off the power of DigiPackⅢ.
2. Save the "DIGIPK3.FWM" file to the USB memory using the computer.
3. Insert the USB memory into the DigiPackⅢ and turn ON the DigiPackⅢ.
4. Turn the rotary knob clockwise while turning on the power.
5. When "Updating firmware ..." appears on the display, the update process is in progress.
※ It takes about 30 seconds to update. If "Failed" is displayed on the screen, or if nothing happens
and screen changed to the startup screen, the upgrade fails. Please try again from process 1. If
"Failed" is inevitably displayed and the upgrade is not successful, there is a possibility that the file
is broken. Please download "DIGIPK3.FWM" again and try update again.
6. Then check the software version in the startup display (Figure 1-4).
7. Turn off the power and remove the USB memory.
Figure 1-4 Start up Display
USB memory is not included with DigiPackⅢ. Refer to section 1-1. for recommended USB.
"DIGIPK3.FWM" can download the latest version from the MOOG website
https://www.moog.co.jp/products/controllers-software/blow-molding-controllers/digipack3.html
To Next Page
Loading...
Need help?
General
