3 or to the required waypoint and press the Menu Select button directly below Sel .
The display shows the distance and bearing from the current to the selected coordinates.
7.22.13
Location Feature in Emergency Mode
When the Emergency feature is activated, the radio exits the Location menu and returns to the Home
screen.
You can view the channel that triggers the emergency signal.
You can reenter the Location menu while still in Emergency mode as long as Silent Emergency is not
activated.
If you have disabled the Location feature on your radio, it automatically turns back on when Emergency
mode is activated.
If there is a solid location signal during Emergency operation, the current location and the location
information received is saved as Emergency and Last Known Location respectively.
7.22.14
Peer-Location on the Display (ASTRO Conventional)
This feature only supports Model 3.5 and Model 2.5.
This feature is only available for radio-to-radio voice transmissions, dispatch call, and selective call.
The transmitting radio and receiving radio must be configured to enable the sending and receiving of
the Global Positioning System (GPS) coordinates.
NOTE: If the receiving radio is operating in a Mixed Mode channel and the voice transmission is
from the conventional ASTRO system, the radio can only receive the peer-location coordinates.
This feature is operable in a Scan Active channel, or Scan Talkback channel.
After receiving a voice transmission with GPS coordinates enabled on the receiving radio, the display
shows the available full location, or short location coordinates.
Full location coordinates
• PTT ID (optional)
• Longitude and latitude
• Relative distance or direction
Short location coordinates
• PTT ID (optional)
• Longitude and latitude
NOTE:
If the transmitting radio is stale at the location after a period of time, the receiving radio display
shows the last known location. If the transmitting radio does not have GPS, or the receiving
radio could not decode the GPS signal of the received signal, the receiving radio display shows
the location as unknown.
7.23
Mission Critical Geofence (ASTRO 25 Trunking)
This feature allows your radio to use the Global Positioning System (GPS) receiver to determine
its location at frequent intervals, and evaluate if the radio is within the Geofence area in real time.
Geofence is a virtual perimeter based on the GPS to define a geographical area on earth.
MN001425A01-AW
Chapter 7 : Advanced Features
111
To Next Page
Loading...
Need help?
General
