For more information, contact your system administrator.
7.10.1
Special Considerations for Emergency Operation
The following scenarios apply during Emergency operation:
Table 6: Emergency Operation Scenarios
Scenario Outcome
If you press the Emergency button while in a
channel that has no Emergency capability,
a tone sounds.
If you change to a channel or mode with no
Emergency capability while in Emergency oper-
ation,
your radio shows the following indications:
• A tone sounds until you select a valid Emer-
gency channel or mode, or until you disable
the Emergency operation.
• The display for Model 3.5 and Model 2.5
shows No emergency.
• The display for Model 1.5 shows NO EMERG.
If you change to a channel or mode with Emer-
gency capability while in Emergency operation,
the Emergency Alarm and/or Emergency Call
continues on the new channel or mode.
If the radio is out-of-range of the system or the
emergency alarm is not acknowledged,
your radio shows the following indications:
• A tone sounds.
• The display shows No acknowledge.
7.10.2
Emergency Keep-Alive
This feature prevents your radio from turning off when in Emergency mode. If this feature is enabled,
you are required to exit Emergency mode before turning off your radio.
7.10.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the programmed Emergency button.
7.10.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. For more information, contact your system
administrator.
Procedure:
1 Perform one of the following actions:
MN001425A01-AW
Chapter 7 : Advanced Features
72
To Next Page
Loading...
Need help?
General
